Buffalo WCR-GN Router Firmware Update Guide
User Drivers » LAN / Network Adapter » Buffalo WCR-GN Wireless Router Firmware Update 1.08
Minimum Requirement
- Compatible OS: Windows 8/7/Vista/XP, Mac OS X 10.4/10.5/10.6/10.7
- Compatible browser: InternetExplorer6.0 or later version, Safari3.0 or later version
- Wired or wireless network interface.
How to update the firmware
- Connecting AirStation and computer individually by wired LAN is recommended for firmware update.
- Start up Windows.
- Please confirm both LAN adapter and AirStation's IP address exist same network segment. Refer to User Manual for IP address setting.
- Select [Run] from Start Menu.
- Enter "http://192.168.11.1/" (AirStation's LAN side IP address) in the field and click "OK" button.
- Enter "root" for user name and keep the password field blank when login prompt appears. Enter proper password if password is configured.
- Click "Update AirStation Firmware" from top screen.
- Click "Browse" button on the right side of "Firmware File Name" then select extracted firmware file, wcrgn-*** (*** depends on firmware version.) and click "Update Firmware".
- The DIAG LED flashes about 3 minutes during firmware update. The LED turns off after firmware update.
* Do not turn the AirStation off when firmware update is performed. (Flashing DIAG LED) It causes malfunction the unit.
Firmware Version Confirmation
- Please refer to above "How to update the firmware" 1 to 3 steps to open setup screen.
- Please click "Diagnostic" tab from top screen to see System Information.
- Confirm Model name is "WCR-GN Ver.1.08".