Dell C2665dnf Color Laser Printer User’s Guide

Installing the Optional 550-Sheet Feeder

1. Ensure that the printer is turned off, and then disconnect all cables from the back of the printer.
2. Remove the tape and the bag holding the screws.
3. Place the optional 550-sheet feeder in the same location that the printer is located.
4. Pull tray1 out of the printer about 200 mm.
5. Hold tray1 with both hands, and remove it from the printer.
6. Lift the printer and align the five guide pins of the optional 550-sheet feeder with the holes at the bottom of the printer. Gently lower the printer onto the optional 550-sheet feeder.
7. Lift the printer and align the five guide pins of the optional 550-sheet feeder with the holes at the bottom of the printer. Gently lower the printer onto the optional 550-sheet feeder.
8. Insert tray1 into the printer, and push until it stops.
9. Re-connect all cables into the back of the printer, and turn on the printer. NOTE: The printer will automatically detect the attached tray but will not detect the paper type.
10. Print the system settings report to confirm that the optional 550-sheet feeder is installed correctly. For details about how to print a system settings report, see “Report / List.”
11. Confirm Tray2 (550 Sheet Feeder) is listed in the system settings report under Printer Options. If the feeder is not listed, turn off the printer, unplug the power cable, and re-install the optional 550-sheet feeder.
12. After loading paper in the optional 550-sheet feeder, specify the paper type from the printer touch panel.
13. If you installed the optional 550-sheet feeder after installing the printer driver, update your driver by following the instructions for each operating system. If the printer is on a network, update the driver for each client.

Configuring the Wireless Adapter Using Dell Printer Setup

1. Insert the Software and Documentation disc provided with the printer on your computer. The Dell Printer Setup program launches automatically.
2. Click Setup.
3. Click Wireless. Follow the on-screen instructions, and configure the wireless setting of the printer.

Reconfiguring the Wireless Setting Using Dell Printer Setup

1. Insert the Software and Documentation disc provided with the printer in your computer. The Dell Printer Setup program launches automatically.
2. Click Configure Printer.
3. Click Wireless Configuration.
4. Follow the on-screen instructions, and change the wireless setting of the printer.

Verifying the Settings Using Operator Panel

1. Press the (Information) button.
2. Tap About This MFP.
3. Tap the Networktab.
4. Verify the IP address displayed in IP(v4) Address.

Verifying the Settings Using System Settings Report

1. Print the system settings report. For details about how to print a system settings report, see “Report / List.”
2. Verify the correct IP address, subnet mask, and gateway address are listed in the system settings report under Network (Wired) or Network (Wireless). If the IP address shows 0.0.0.0 (the factory default), an IP address has not been assigned. To assign one for your
printer, see “Assigning an IP Address.”

Categories: Printers